Item# PAPOS-14075

Proactive Environmental Products®

PRO SOLAR CHARGER #1

 

Maximize Your Solar Power!

 

Set it and Forget it!

Weatherproof Pro Solar Charger #1 Delivers Autonomous Pump Control with Variable

Flow to Low Flow Control, and Proactive® Liquid Detection

Sensor (LD), Multiple Settings Timer, and Tank Float Switch Technologies

 

 

 

 

 

 

 

 

 

 

                

 

      

 

 

 

The Pro Solar Charger #1 is compatible with the

Proactive Environmental Products® pumps listed below:

 

Abyss® and Abyss® Slimline pumps

Poseidon® 60 and Poseidon® 80 pumps

Frontier® 60 and Frontier® 80 pumps

SS Mini-Monsoon® XL 60 and SS Mini-Monsoon® XL 80 pumps

 

If you plan to power the Proactive® brand pumps listed above with other means of energy, please contact us to discuss the full line of Proactive® Autonomous Pump Control System options for: Solar Direct, 110/220 AC to 12 volt DC output, 12 volt DC battery / 12 volt DC battery bank, or gas generator. For your convenience, videos referencing Selecting Power and Autonomous Setup are available for all pumps listed above on our website.

 

Applications of the Pro Solar Charger #1: When using the Abyss®, Poseidon® 60 and 80, and SS Mini Monsoon® XL 60 and 80 series pump lines include, but not limited to:

24/7 stationed applications in groundwater, surface water, vaults or the like for: Pump Tests, Long or Short Term Purge, Remediation, Liquid Transfer, Groundwater and Surface Water Monitoring

 

Applications of the Pro Solar Charger #1: When using the Abyss® and SS Mini Monsoon® XL 60 and 80 series pump lines include, but not limited to:

24/7 stationed applications in groundwater, surface water, vaults or the like for: Pump Tests, Long or Short Term Purge, Remediation, Liquid Transfer, Groundwater and Surface Water Monitoring, Hydrocarbon Recovery [LNAPL/DNAPL]

 

Applications of the Pro Solar Charger #1: When using the Frontier® 60 and 80 series pump lines

Stationed application for cabin use or remote off the grid recreational use

 

 

 

 

 

 

Option #1: LD Sensor Detection and Dry Run Detection Feature

The LD sensor detects (conductive) liquid*. The pump will run as long as the LD sensor is suspended in liquid. When liquid draws down below the LD sensor, the dry run sensor transmits a signal to the Pro Solar Charger #1 to shut-off the pump. As liquid level rises again covering the LD sensor, the LD sensor takes over and transmits a signal to the Pro Solar Charger #1 to turn-on the pump. This pumping cycle continues automatically.

 

Option #2: Tank Float Switch Feature

This feature prevents tank over-fill and provides control over the desired total volume of liquid that enters the tank. The tank float switch transmits a signal to the Pro Solar Charger #1 to shut-off the pump when it detects the full or desired set point (assigned during tank float switch deployment). The pump remains off until the tank reservoir drops to tank float switch set point, triggering the tank float switch to transmit a signal to the Pro Solar Charger #1 to turn-on the pump again. This pumping cycle occurs automatically.

 

Option #3: Multiple Settings Timer Feature

The Pro Solar Charger #1 timer provides up to 19 pumping cycles within a 24 hour period, delivering total autonomous pump run times and control over pump run time duration. This pumping cycle occurs automatically.

 

Option #4: Variable Flow with Low Flow Control Feature

Incorporating this feature provides adjustable flow rate control for a continual and consistent liquid discharge which is ideal for low-yielding wells, vaults, or fluctuating water levels in surface water.

 

Option #5: Incorporate all Features

The Variable Flow Rate with Low Flow Control, LD and Dry Run Detection Sensors, Tank Float Switch and Multiple on/off Interval Timer Settings provide the ultimate experience in autonomous pump control available!

Absolute Pump Control ~ you're going to love the way you work!

 

SOLAR CHARGER

INTERNAL FUSE #1

BREAKER

BREAKER

TIMER

LIQUID DETECTION SENSOR PROBE

LOW FLOW CONTROLLER

GREY

TERMINAL BAR

DRY

SENSOR PROBE

TANK FLOAT SWITCH

PRO Solar Charger #1  

The Ultimate Solar Powered Pump Control with Liquid Detection Sensor Technology

Configure the Pro Solar Charger #1 the Way You Want It!

  • Ideal for remote sites

  • Designed for the Poseidon®, SS Mini Monsoon® XL,  and Frontier® 60 and 80 pump series, as well as the Abyss® pump series

  • Incorporated into the most economical, intuitive, and simple to use solar powered autonomous pump control on the market

  • Improves time management! Literally set the Proactive® 80 amp Solar Charger and autonomous settings with pump and forget it

  • Saves money by eliminating archaic, bulky, and expensive equipment

  • Reduces carbon footprints

  • Use of the LD with Dry Run autonomous pump control sensors manages pump operation so you don’t have to

  • Reliable LD Sensor runs the pump only when liquid is present* 

  • Same pump flow rate recognition through autonomous pumping cycles  

  • Flexibility to choose the autonomous options that will get the job done accurately, faster, and under budget

  • Additional and customized LD and Dry Run Sensor wire length is available upon request at time of order

  • User-friendly, one time simple setup

  • Look like a PRO when your clients see how much money you save them by deploying Pro Solar Charger #1 with Proactive® Autonomous Pump Control Technologies

  • Ideal pump management when transferring liquid to a tank

  • Prevents tank over-fill 

  • Provides control over the desired total volume of liquid that enters the tank 

  • Same pump flow rate recognition through autonomous pumping cycles

  • Provides peace of mind knowing that the tank float switch will mind the pumping operation so you don't have to

  • User-friendly, one time simple setup

  • Provides ultimate pump management!

  • Using the timer settings feature controls the pump run times and duration of pump run time

  • Offers up to 19 reliable pumping cycles within a 24 hour period

  • Gives you control over how long the pump will run for during each pumping cycle 

  • Proven to be most effective for autonomous pump control when coupled with Proactive® LD Sensor technology

  • Same pump flow rate recognition through each autonomous pumping cycle

  • Controlled pumping cycles may extend pump life

  • User-friendly, one time simple setup

  • Ideal for short and long term groundwater purge and pump tests with desired flow rate

  • Offers adjustable flow rate for a continual and consistent flow

  • Ideal for low flow control with low-yielding wells, vaults, and other low-yielding applications

  • Capable of reducing flow to 10 mL per minute when used in conjunction with Proactive® low Flow Valve (Proactive® low flow valve is sold separately)

  • Controlled flow rate reduces the amount of pump cycles and may prolong pump life

  • May reduces well stress

  • Same pump flow rate recognition through pumping cycles

  • Proactive® Solar charger handles up to 80 amps input allowing for a large solar panel array

  • Intelligent Proactive® 80 Amp Solar Charger identifies and auto adjusts to 12 or 24 volt solar panels (this means you do not need a 24 to 12 volt step down unit!)

  • Easy-to-read LCD Display

  • User-friendly operation interface

  • State-of-the-art Pulse Width Modulation (PWM) is incorporated, providing reliable, effective, and consistent charging

  • Intelligent battery reverse discharge protection

  • Intelligent battery reverse polarity protection 

  • Low Voltage Disconnect (LVD) battery protection 

  • Intelligent overload feature with short circuit protection

  • Intelligent automatic temperature compensation

  • Provides consistent amp and 12 volt DC output to the pump for consistent flow rate

  • User-friendly, one time simple setup 

  • Incorporated into weatherproof enclosure

  • Provides autonomous pump management

  • The pump will run as long as the LD sensor is suspended in liquid*. When liquid draws down below the LD sensor, the dry run sensor transmits a signal to the Pro Solar Charger #1 to shut-off the pump

  • As liquid level rises again covering the LD sensor, the LD sensor takes over and transmits a signal to the Pro Solar Charger #1 to turn-on the pump

  • This pumping cycle continues automatically

  • Same pump flow rate recognition through each autonomous pumping cycle

  • Purposefully sleek and narrow LD and Dry Run Sensor wires and probes designed to accommodate both the pump and sensors in 2” and larger diameters wells

  • LD Sensor probes also serve as wire weights

  • User-friendly, one time simple setup

  • Provides tank overfill protection

  • The tank float switch transmits a signal to the Pro Solar Charger #1 to shut-off the pump when it detects the full or desired set point (assigned during tank float switch deployment) 

  • The pump remains off until the tank reservoir drops to tank float switch set point, triggering the tank float switch to transmit a signal to the Pro Solar Charger #1 to turn-on the pump

  • The pumping cycle continues automatically

  • Same pump flow rate recognition through each autonomous pumping cycle

  • Increased effectiveness when used in conjunction with LD and Dry Run Sensor technology

  • Can be deployed in tank or vault long distances from power supply with added wire

  • Tank float switch comes with 3 feet of wire. Additional wire is available (sold by the foot upon time of order)

  • User-friendly, one time simple setup

  • Sophisticated yet easy to program timer provides 19 reliable pumping cycle settings within a 24 hour period

  • Delivers control over the duration of pump run time per pumping cycle

  • Pumping cycles occur automatically

  • Same pump flow rate recognition through each autonomous pumping cycle

  • Controlled pumping cycles may extend pump life

  • Using the multiple settings timer feature may reduce well stress 

  • Increased effectiveness when used in conjunction with LD and Dry Run Sensor technology

  • Easy to read LCD lit display

  • User-friendly, one time simple setup

  • A simple turn of the rheostat provides variable flow to low flow control

  • Capable of reducing flow to 10 mL per minute when used in conjunction with Proactive® low Flow Valve (Please do not valve pump without the use of a the low flow control feature)

  • Providing variable flow balances well recovery to pump purge rate

  • Controlled flow may reduce the amount of pumping cycles, ergo prolonging pump life

  • Controlled flow may reduce well stress

  • User-friendly, one time simple setup

Pro Solar Charger #1 comes with:

  • Weatherproof enclosure providing long life and protection to the components

  • 80 amp Solar Charger

  • Built-in Variable Flow and Low Flow Controller 

  • Built-in Multiple Settings Timer

  • Built-in 30 amp breakers

  • Liquid Detection Sensor and Dry Run Sensor probes come with: 

         ○ 300 feet of wire per sensor spooled onto reel 

  • Tank Float Switch comes with 3 feet of wire (additional wire can be purchased upon request at time of order)

  • Tamper-Proof lock for peace-of-mind

  • Mounting Brackets 

  • Warranty: Manufacturer 6 months parts and labor warranty

Specifications:

 

DC VOLT MAX:                                     12-24V

MAXIMUM AMP OUTPUT:                    25 AMPS

MAXIMUM AMP INPUT:                       80 AMPS

DEPTH MEASUREMENT:                        8"

WIDTH MEASUREMENT:                       17" 

HEIGHT MEASUREMENT:                       21"

WEIGHT:                                              19 POUNDS   

INTERNAL FUSE:                                   25 AMP

BREAKERS:                                           30 AMP 

ENCLOSURE RATED:                              WEATHERPROOF

Note: Product dimensions are inclusive of the Pro Solar Charger #1 NOT inclusive of the sensors, reels, or tank float switch. 

* Liquid must contain minerals in order to use the LD sensor 

Pro Solar Charger #1

Requires one of the following pumps:

Our Location: 1767 Lakewood Ranch Blvd, Suite #113 Bradenton Florida 34211

Phone: 1.941.243.3930

Call Us Toll Free At:  (1.877.99.HYDRO) 

Note: Prices on our website are in USD

State Groundwater Sampling Procedures:

  • Alabama Groundwater Monitoring Well Sampling Procedures

  • Alaska Groundwater Monitoring Well Sampling Procedures

  • Arizona Groundwater Monitoring Well Sampling Procedures

  • Arkansas Groundwater Monitoring Well Sampling Procedures

  • California Groundwater Monitoring Well Sampling Procedures

  • Colorado Groundwater Monitoring Well Sampling Procedures

  • Connecticut Groundwater Monitoring Well Sampling Procedures

  • Delaware Groundwater Monitoring Well Sampling Procedures

  • Florida Groundwater Monitoring Well Sampling Procedures

  • Georgia Groundwater Monitoring Well Sampling Procedures

  • Hawaii Groundwater Monitoring Well Sampling Procedures

  • Idaho Groundwater Monitoring Well Sampling Procedures

  • Illinois Groundwater Monitoring Well Sampling Procedures

  • Indiana Groundwater Monitoring Well Sampling Procedures

  • Iowa Groundwater Monitoring Well Sampling Procedures

  • Kansas Groundwater Monitoring Well Sampling Procedures

  • Kentucky Groundwater Monitoring Well Sampling Procedures

  • Louisiana Groundwater Monitoring Well Sampling Procedures

  • Maine Groundwater Monitoring Well Sampling Procedures

  • Maryland Groundwater Monitoring Well Sampling Procedures

  • Massachusetts Groundwater Monitoring Well Sampling Procedures

  • Michigan Groundwater Monitoring Well Sampling Procedures

  • Minnesota Groundwater Monitoring Well Sampling Procedures

  • Mississippi Groundwater Monitoring Well Sampling Procedures

  • Missouri Groundwater Monitoring Well Sampling Procedures

  • Montana Groundwater Monitoring Well Sampling Procedures

  • Nebraska Groundwater Monitoring Well Sampling Procedures

  • Nevada Groundwater Monitoring Well Sampling Procedures

  • New Hampshire Groundwater Monitoring Well Sampling Procedures

  • New Jersey Groundwater Monitoring Well Sampling Procedures

  • New Mexico Groundwater Monitoring Well Sampling Procedures

  • New York Groundwater Monitoring Well Sampling Procedures

  • North Carolina Groundwater Monitoring Well Sampling Procedures

  • North Dakota Groundwater Monitoring Well Sampling Procedures

  • Ohio Groundwater Monitoring Well Sampling Procedures

  • Oklahoma Groundwater Monitoring Well Sampling Procedures

  • Oregon Groundwater Monitoring Well Sampling Procedures

  • Pennsylvania Groundwater Monitoring Well Sampling Procedures

  • Rhode Island Groundwater Monitoring Well Sampling Procedures

  • South Carolina Groundwater Monitoring Well Sampling Procedures

  • South Dakota Groundwater Monitoring Well Sampling Procedures

  • Tennessee Groundwater Monitoring Well Sampling Procedures

  • Texas Groundwater Monitoring Well Sampling Procedures

  • Utah Groundwater Monitoring Well Sampling Procedures

  • Vermont Groundwater Monitoring Well Sampling Procedures

  • Virginia Groundwater Monitoring Well Sampling Procedures

  • Washington Groundwater Monitoring Well Sampling Procedures

  • West Virginia Groundwater Monitoring Well Sampling Procedures

  • Wisconsin Groundwater Monitoring Well Sampling Procedures

  • Wyoming Groundwater Monitoring Well Sampling Procedures